- Outside use
-
Omni-directional
-
3-4 dB Gain
-
2G, 3G, 4G, WLAN
-
Full-band
-
Weather resistant
-
Easy to install
This wall or roof mount antenna is ideal for downtown urban settings, RV’s or marine installations. It’s built with a strong fiberglass casing and is designed to cover 2G/3G/4Gand WLAN systems for Cellular, PCS, AWS and LTE frequencies.
The CM288W Full Band Fiberglass antenna is an omni-directional antenna that gathers signals from all sides and does not need to be pointed toward a cellular tower. Range of antenna is approximately 50 miles to and from cellular towers free of obstructions.Besides the antenna itself, parts includes mounting equipment for either a flat horizontal surface or a wall. It should be mounted in an upright position for best results
The CM288W is compatible with the following SureCall products:
Amplifier Compatibility: all 4G boosters series(CM700, CM2100, CM2500), RV boosters(CM2000-WL 45dB), Accelerator kit (CMAK-4G) , all SOHO boosters series(CM2000-WL 62db, CM2000-W 55dB), all In-building amplifiers series(CM2020,FORCE 5)
Cable compatibility: LOW Coax Cables WITH N MALE ON EITHER side(CM400, CM240 etc.)
|
Frequency
|
698-960/1700-2700MHz
|
|
input impedance
|
50 ohm
|
|
Operating Temperature
|
-22° F Degrees to +176° Degrees
|
|
Antenna Gain
|
3-4dB
|
|
Beamwidth
|
E:72 H:92/ E:50 H:80
|
|
VSWR
|
≤1.8
|
|
Polarization Type
|
Vertical
|
|
Radiation
|
Omni-directional
|
|
Maximum Power
|
100W
|
|
Connector type
|
N-Female or based on customer request
|
|
Weight
|
1 lb
|
|
Ground Plane
|
Built-in ground plane
|
|
Mount
|
Mounts on roof or wall
|
|
Color
|
White
|
|
Dimensions
|
9.5” x 3.9”
|
|
Material
|
Fiberglass
|
|
Height (inches)
|
8.5
|
|
Diameter
|
2.63
|
Step 1: Unscrew antenna from L-mounting bracket from antenna base with hands, or wrench if needed
Step 2: Using vertical plate of bracket, mark position of desired placement with pencil or marker.
Step 3: Unscrew nut on end of stucco screw and remove it along with lock washer and regular washer.
Step 4: Place vertical plate into desired location and tap the screw, head first, along with sleeve, into stucco ½” to 5/8” deep into place.
Step 5: In this order, place washer, lock washer and nut on each screw and tighten until secure. When tightening screw, sleeve will expand to secure plate.
Step 6: Screw antenna securely back onto horizontal plate.
Note: If desired location for plate is wood or concrete, wood or masonry screws for L-plate will have to be purchased separately.
