SC-222W | 3G 4G Dome Antenna

3dBi ( 698-2700Mhz) | Ideal for building systems indoor use

  • Inside use
  • Omni-directional
  • 2 - 5 dB Gain
  • 2G, 3G, 4G, WLAN
  • Ceiling mount recommended
  • Easy to install
  • Includes mounting equipment


This full band dome antenna is designed to be unobtrusive with a low profile that blends easily with your internal environment.  The full band antenna is designed to cover 2G/3G/4G and WLAN systems for Cellular, PCS, AWS and LTE frequencies.  This ceiling mount antenna transmits and receives to cell phones with a 360 degree beamwidthe

CM222W multi band plastic antenna is an omni-directional interior antenna that gathers signals from all sides and does not need to be pointed toward a cellular tower. Range of antenna is dependent on three factors:

1) physical obstructions

2) power generated by booster/amplifier

3) reception from outside signal received and distributed by outside antenna

.Besides the antenna itself, parts include mounting equipment for either a flat horizontal surface or a wall.  It should be mounted in an upright position for best results.


Frequency 698-960/1700-2700
Input Impedance 50 ohm
Antenna Gain 2±0.5dBi/5±0.5dBi
Beamwidth 360 Degrees
VSWR ≤2.0
Polarization Type Vertical
Radiation Omni-directional
Maximum Power 50W
Connector type N-Female
Height (inches) 3.5”
Diameter 7.25”
Weight 10.5 oz
Ground Plane Built in ground plane
Mount Mounts to ceiling
Color White
Cable type CM240 or CM400


This CM222W full-band antenna is a omni-directional antenna designed to cover 360° for 2G/3G/4G and WLAN systems for Cellular, PCS, AWS and LTE frequencies. It’s a high gain indoor antenna suited for places where the signal needs to be broadcast over a central area or space. This ceiling mount antenna transmits and receives signal to cell phones.

 

Installation Steps

1.   1. Choose a location on the ceiling accessible from above to run antenna cable to signal booster. Make sure your location for the inside antenna allows for necessary separation between inside and outside antenna. See antenna separation table previously shown).

2.   2. Drill a 3/8” diameter hole in the ceiling. The ceiling thickness should be ½”

3.   3. Unscrew fixing nut from antenna. Place antenna cable through hole. Screw fixing nut back onto antenna base and cable on attic side of ceiling and fasten.

4.   4. Attach the connection from the interior antenna to the cable leading to the connector labeled INSIDE on your booster

5. Hand-tighten fixing nut to secure antenna

 

Storage and transportation: Place in non-extreme room temperature and dry environment. Not to be placed near fireplace or open flame.