Boosts Cell Signal On:
Improve your cell signal for all US carriers inside any home, cabin, small building or office up to 3,000 square feet. Flare 3.0® takes the multi-award winning SureCall Flare model one step further to deliver even more cellular reliability to homes in remote areas.
Flare 3.0 comes kitted with a Yagi-directional antenna and an average 9 dB increase in uplink power for the frequencies that are most commonly used in rural areas. Together, the increased uplink and upgraded antenna pack the Flare 3.0 with 8X more connecting power for homes and offices in the most challenging signal locations.
Improves cell service for all US carrier’s voice, text and 4G LTE data signals
Increases signal strength & extends battery life for multiple users on all cellular devices, up to 3,000 sq ft
Significantly improved uplink power and high-gain Yagi antenna for best performance in the toughest environments without sacrificing performance in urban locations
Newly added gain expands indoor cell coverage for those located at the edge of the network
Simple to set up with all components included for a light DIY install
- Industry best 3-year warranty and lifetime US-based tech support
HOW IT WORKS
Flare 3.0 has combined the booster and indoor antenna to streamline the system's design for easier installation and an attractive, low-profile appearance. The stylish one-piece base unit is designed to be placed on an open tabletop or shelf for clearer and more reliable voice and data performance.
Signal is delivered to the Flare 3.0 booster with the included outdoor Yagi antenna and 50 feet of premium RG-6 cable. The outdoor antenna captures signal from the cell tower and the all-carrier booster amplifies it and distributes the enhanced signal to all mobile devices within the booster’s coverage area. Flare 3.0 then amplifies outgoing signal back to the cell tower.
Flare 3.0 indoor booster, high-gain Yagi antenna with mounting hardware, RG-6 cable (50 ft), AC power supply, quick setup guide
|Uplink Frequency Range (MHz):||698-716 / 776-787 / 824-849 / 1850-1915 / 1710-1755 (G Block Included)|
|Downlink Frequency Range (MHz):||728-746 / 746-757 / 869-894 / 1930-1995 / 2110-2155 (G Block Included)|
|Donor/Server Port Impedance:||75 Ohm / 50 Ohm|
|Maximum Gain:||72 dB|
|Noise Figure:||7 dB|
|Supported Standards:||CDMA, WCDMA, GSM, EDGE, HSPA+, EVDO 4G LTE and all cellular standards|
|AC Input:||Input: AC 110 – 240 V, 60 Hz ; Output: DC 5V / 3A|
|Maximum Output Power:||1 Watt EIRP|
|Cable:||RG-6 (50 ft)|
|Dimensions:||5.125" × 7.25" × 5.625"|
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider.
- You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person.
- You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.
- WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.
- Please note, the four largest carriers - AT&T, T-Mobile, Verizon and Sprint - and more than 90 regional carriers have given blanket consent for use of all boosters certified to the new FCC standards.